H3C SFP-GEB-T-IL Compatible 1G SFP SGMII Transceiver Module

Product Highlights

• Compatible alternative to H3C SFP-GEB-T-IL
• 1G connectivity at 1000Mbps
• Specified reach: 100m
• RJ-45 / Cat 5 interface
• Operating temperature: -40 to 85°C (-40 to 185°F)
• Factory compatibility verification and electrical performance testing before shipment

Specifications

Rack Integration and Service Access

Plan the fiber route before removing connector protection. The patch lead should follow its manager without pulling on the transceiver, while leaving space to release the latch and service adjacent ports. Protect the end face until final connection and avoid tight bends immediately behind warm exhaust air. For this model, the principal parameters are data rate 1000Mbps, rated reach 100m.

Applications and Optical Link Design

This copper transceiver is intended for short equipment links over the twisted-pair cabling category stated in the specifications. Typical uses include switch-to-server, switch-to-switch and rack-level connections where an RJ-45 interface is preferred over fiber. Use the required cable category, observe the rated distance and confirm that the host supports the module’s speed, power consumption and electrical operating modes.

The industrial temperature rating makes this version appropriate for controlled outdoor cabinets, transport nodes and other installations exposed to wider ambient temperature variation. Adequate airflow, protected cable routing and host-platform temperature limits still apply.

For this copper interface, use the stated cable category and keep the channel within 100m. Patch-cord construction, connector quality and auto-negotiation can affect the result. Verify the negotiated speed and diagnostics at both ends rather than assuming every RJ-45 port behaves identically.

Optical Acceptance, Diagnostics and Handling

Use the electrical and optical limits in the specification table as the acceptance reference for this model. During commissioning, record the host diagnostic readings after the link has stabilized and compare them with those limits. DOM values are useful operational indicators, but they do not replace calibrated optical measurements when a link is marginal. Investigate unexpected loss through connector inspection, cleaning and a channel measurement before replacing the module. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Quality Assurance and Packaging

Quality control covers the optical or electrical interface, host identification and operating link. The verified unit is then individually protected and cartoned. Customer references, rack groups and project packing lists can be added for volume orders.

H3C Compatibility and Factory Testing

Factory verification starts with the expected SFP-GEB-T-IL identity and finishes with an operating host link. EEPROM data, diagnostic visibility and the stated optical parameters are assessed together. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Frequently Asked Questions

Ordering Information

When ordering, specify SFP-GEB-T-IL, SFP-GEB-T-IL, quantity and intended host platform. Project labels can repeat these details for receiving and asset records. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.