Generic DWC17-SFP1G-120 Compatible 1G SFP Transceiver Module

Product Highlights

• Compatible alternative to Generic DWC17-SFP1G-120
• 1G connectivity at 1000Mbps
• Optical wavelength: 1563.86nm
• Specified reach: 120km
• Duplex LC / SMF interface
• Operating temperature: 0 to 70°C (32 to 158°F)
• Factory compatibility verification and optical performance testing before shipment

Specifications

Rack Integration and Service Access

Plan the fiber route before removing connector protection. The patch lead should follow its manager without pulling on the transceiver, while leaving space to release the latch and service adjacent ports. Protect the end face until final connection and avoid tight bends immediately behind warm exhaust air. For this model, the principal parameters are data rate 1000Mbps, wavelength 1563.86nm, rated reach 120km.

Applications and Optical Link Design

Use this module for equipment interconnection over the specified single-mode fiber plant, including enterprise backbone, campus, metro or data-center interconnect links according to its rated distance. Confirm that both ends use the same optical standard and wavelength plan, and allow for connector, splice and patch-panel loss within the stated power budget.

Before deployment, check the host port type, supported data rate and firmware requirements. The 1G interface configuration must match the remote equipment; sharing a SFP housing alone does not make two transceiver types interoperable.

Wavelength-selective links require the exact channel plan at both ends. Confirm that filters pass 1563.86nm, then include their insertion loss in the 120km power budget. A nearby channel is not a substitute for the specified wavelength.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is 0~5dBm; receiver sensitivity is < -30dBm; the stated optical power budget is 30dB. A sound acceptance record includes link state, diagnostic temperature, supply voltage and transmit or receive levels where the host exposes them. Compare the readings with the stated ranges rather than treating any received light as proof of adequate margin. Persistent alarms or borderline values should trigger an end-face and complete-channel inspection. Diagnostic monitoring is listed as Supported. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Quality Assurance and Packaging

Quality control covers the optical or electrical interface, host identification and operating link. The verified unit is then individually protected and cartoned. Customer references, rack groups and project packing lists can be added for volume orders.

Generic Compatibility and Factory Testing

Factory verification starts with the expected DWC17-SFP1G-120 identity and finishes with an operating host link. EEPROM data, diagnostic visibility and the stated optical parameters are assessed together. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Frequently Asked Questions

Ordering Information

Use DWC17-SFP1G-120 as the compatibility cross-reference and DW-SFP1G120-17 as the HT ordering identity. Keep other reaches or wavelength directions on separate order lines. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.