Generic SFP-1G35-BXMMF Compatible 1G SFP Transceiver Module

Product Highlights

• Compatible alternative to Generic SFP-1G35-BXMMF
• 1G connectivity at 1.25Gbps
• Optical wavelength: 1310nm-TX/1550nm-RX
• Specified reach: 500m
• Simplex LC / MMF interface
• Operating temperature: 0 to 70°C (32 to 158°F)
• Factory compatibility verification and optical performance testing before shipment

Specifications

Rack Integration and Service Access

Plan the fiber route before removing connector protection. The patch lead should follow its manager without pulling on the transceiver, while leaving space to release the latch and service adjacent ports. Protect the end face until final connection and avoid tight bends immediately behind warm exhaust air. For this model, the principal parameters are data rate 1.25Gbps, wavelength 1310nm-TX/1550nm-RX, rated reach 500m.

Applications and Optical Link Design

Typical deployments include switch-to-switch, switch-to-server and aggregation links inside a data hall or between adjacent equipment rooms. The Simplex LC interface connects to the specified multimode cabling, and the stated reach depends on fiber grade and link loss. Keep this interface on the matching multimode optical standard rather than connecting it directly to a single-mode wavelength or reach variant.

Before deployment, check the host port type, supported data rate and firmware requirements. The 1G interface configuration must match the remote equipment; sharing a SFP housing alone does not make two transceiver types interoperable.

BiDi operation saves a fiber strand but makes wavelength orientation critical. Record the part installed at each end and check its paired receive wavelength. The 500m rating still depends on total channel loss, including connectors and splices.

Optical Acceptance, Diagnostics and Handling

For this model, the specified transmit-power range is -9~-3dBm; receiver sensitivity is < -21dBm. During commissioning, record the host diagnostic readings after the link has stabilized and compare them with those limits. DOM values are useful operational indicators, but they do not replace calibrated optical measurements when a link is marginal. Investigate unexpected loss through connector inspection, cleaning and a channel measurement before replacing the module. Before every insertion, keep dust caps in place until the patch lead is ready, avoid touching the optical end face and use an appropriate inspection and cleaning procedure. Do not look into an active optical interface.

Quality Assurance and Packaging

Before packing, the module receives interface inspection, identification and link checks. Protective packaging avoids pressure on the connector and latch. Customer references, rack groups and project packing lists can be added for volume orders.

Generic Compatibility and Factory Testing

Factory verification starts with the expected SFP-1G35-BXMMF identity and finishes with an operating host link. EEPROM data, diagnostic visibility and the stated optical parameters are assessed together. Equipment model, hardware revision and software release can be reviewed before dispatch where platform behavior is uncertain.

Frequently Asked Questions

Ordering Information

Use SFP-1G35-BXMMF as the compatibility cross-reference and SFP-1G35-BXMMF as the HT ordering identity. Keep other reaches or wavelength directions on separate order lines. Neutral labels, customer packaging and project-specific compatibility review are available on request.

Shipping and Lead Time

Standard configurations normally ship within one to three working days, with production lead times confirmed for larger quantities. International courier, air freight and sea freight are available; customer courier accounts and nominated forwarders are accepted.